Equipment Repair & Installation

Most equipment failures start upstream

Equipment does not usually fail on its own. It fails because of what has been running through it.

Chemistry out of balance for months is hard on seals, cells, and heat exchangers. A filter that has not been cleaned on schedule makes the pump work against pressure it was not sized for. Water levels that sit too low pull air into the suction side and cook the pump seal.

This is where Pat’s water chemistry background earns its keep. When we replace something we want to know why it failed, because otherwise we will be back replacing the same thing in two years and you will reasonably wonder why.

Weekly service includes an equipment check every visit, which is how most of our customers stop having equipment emergencies.

Contact Us Today
Image

What We Work On

Salt chlorine generators

Cell replacement, board diagnosis, and new system installation. Salt systems fail in a small number of predictable ways, and a low salt reading is frequently not a salt problem at all.

Heaters

Gas and heat pump. Diagnosis, repair, and replacement. A heater that lights and then shuts down has a specific set of causes and is worth diagnosing properly, because the parts are not cheap and replacing the wrong one is expensive twice.

Filters

Cartridge, DE, and sand. Cleaning, element and grid replacement, multiport valve repair, and new installs when the tank is done. Most filter complaints turn out to be pressure problems, and pressure problems usually point at the pump or the plumbing rather than the filter.

Pumps

Repair, replacement, motor and seal work, and full changeovers to variable speed. If your pool still runs a single speed pump, that is usually the largest recurring cost on the whole pool and the easiest one to cut. We show you the math on your actual pool and run time rather than a generic savings number.

Plumbing

Valves, unions, returns, skimmer lines, and full pad rebuilds. When enough of the pad is failing at once, rebuilding it properly costs less than repairing it four more times.

Lights

LED conversions and fixture replacement. Swapping an old incandescent fixture for LED is one of the few upgrades that pays for itself and changes how the backyard looks at night.

Automation & controls

Timers, controllers, valve actuators, and app-based systems. We install them, repair them, and sit down and show you how yours works, which is more than most people got when theirs went in.

When Should I Call About Equipment?

  • The heater fires and shuts off, or will not fire at all.

  • The pump runs but the water barely moves, or filter pressure climbed and stayed there.

  • The salt system reports low salt after you added salt.

  • The pump is louder than it used to be, or has started to whine or grind. Bearings do not get better.

  • Air bubbles come out of the returns, which usually means the suction side is pulling air.

  • The equipment pad is wet when it has not rained.

  • Your electric bill went up and nothing else in the house changed.

Image

Should I repair or replace my pool equipment?

We give you both numbers and our recommendation, and we tell you if the honest answer is to run it another season and revisit in the fall.

  • Repair

    When the failed part is discrete, the rest of the unit has life in it, and the part costs a fraction of a new one. A pump seal, a filter grid, a valve actuator, a control board on an otherwise healthy heater.

  • Replace

    When the repair costs more than half of a new unit, when the unit is old enough that the next failure is already coming, or when replacing buys you something the repair cannot. That last one is where variable speed pumps live. Rebuilding a fifteen year old single speed pump is possible and almost always the wrong call, because the new pump pays for the difference in electricity.

Request A Quote

Should I repair or replace my pool equipment?

We give you both numbers and our recommendation, and we tell you if the honest answer is to run it another season and revisit in the fall.

  • Repair

    When the failed part is discrete, the rest of the unit has life in it, and the part costs a fraction of a new one. A pump seal, a filter grid, a valve actuator, a control board on an otherwise healthy heater.

  • Replace

    When the repair costs more than half of a new unit, when the unit is old enough that the next failure is already coming, or when replacing buys you something the repair cannot. That last one is where variable speed pumps live. Rebuilding a fifteen year old single speed pump is possible and almost always the wrong call, because the new pump pays for the difference in electricity.

Request A Quote
Image

Equipment Repair & Installation FAQs

The pump varies by horsepower and whether you go single or variable speed, plus labor and any plumbing modifications the new unit needs. Variable speed costs more up front and less every month after. We quote the specific pump for your pool and show both options side by side.

Contact

Have questions about pool maintenance, custom patio builds, or scheduling a service consultation? Reach out to the Pat's Pool and Patio team today. We are here to help bring your outdoor oasis to life!